DIY: Use El Wire to Light your Cupcake Tree
I clipped the battery pack to the bottom tier
of the cupcake tree and then used UGlu Dashes
to attach the el wire around the edge of the bottom tier.
Held the el wire firmly, even the next day.
btw: There is enough room for ribbon trim on the edge also.
Once you have encircled the edge of the bottom tier
use the center divider to take the el wire up to the the next tier.
If you have extra el wire when you reach the top tier just
continue wrapping it around until you reach the end.
Then place the orb on the top.
Variations on the design:
Decorate each tier with wrapping paper.
Use sound activated el wire. Or use two different colors of elwire
and set them to flash at different speeds.